Detailed Specifications Getrag four-speed gearbox with Borg-Warner synchromesh in all forward gears. Gear shifting is performed by a lever on the body floor tunnel. Types of gearboxes...
Details of the crankcase of a four-speed gearbox Details of the four-speed gearbox housing: A - until August 1977; B - since August 1977. 1 - gearbox housing; 2 - the front cover of the gearbox, combined into...
Removal and installation of a transmission Withdrawal Disconnect the wires from the battery terminals and, acting from the engine compartment, unscrew the bolts securing the gearbox housing to the...
Gearbox disassembly Remove the rear crossmember and muffler exhaust pipe mounting bracket. Install the gearbox on the turntable 23 0 050 for disassembly. Drain the oil from the...
Disassembly of the gearbox shafts Remove the input shaft, remove the synchronizer ring and press the bearing off the end of the output shaft. Remove the snap ring, thrust washer, adjusting...
Gearbox shaft assembly Measure the width of the guide ribs of the shift forks, which should be within 5±0.1 mm. Check for excessive wear of the blocking rings of the synchronizers:...
Intermediate Shaft Assembly Heat the gears of III and IV gears to a temperature of 120-150°C. When pressing the gears of III and IV gears onto the intermediate shaft, it is necessary to...
Gearbox Assembly Determining the thickness of the adjusting ring installed between the speedometer drive gear and the output shaft rear bearing measure distance «WITH» between...