Car clutch and drive shafts BMW 3 Series E46

Clutch and Drive Shaft Specifications
Individual characteristics are also given in the text of the Chapter and, if their implementation is mandatory, are highlighted in bold. Clutch Hinge diameter...

Clutch device
1 - slave disk 2 - pressure plate 3 — clutch release bearing 4 — clutch release lever 5 — bolt 6 - ball pin 7 - spring clamp The models under consideration are...

Removal and installation the clutch
The BMW 3 Series uses a self-adjusting clutch (SAC - Self Adjusting Clutch). When removing and installing this clutch, it is essential to press the pressure...

Removal and installation the clutch release bearing
Noise in the clutch release bearing when the clutch pedal is pressed, indicates damage to the bearing. When replacing the driven disk, it is recommended to...

Bleeding air from the clutch drive
The air from the hydraulic clutch drive must be removed if the clutch pedal does not return or returns slowly, the clutch does not disengage well, and if the...

Removal and installation the clutch slave cylinder
Since the hydraulic clutch system operates on brake fluid, read the relevant instructions in Chapter Bleeding the brake system . Brake fluid is poisonous....

Removal and installation drive shafts
Drive shaft with protective covers 1 — drive shaft. Joint diameter - 93 mm 2 - bar 3 - cylindrical screw or Torx 4 - hub mounting nut 5 - retaining ring 6 —...

Replacing the drive shaft protective cover
Removal 1. Remove the drive shaft and clean it. 2. Use side cutters to cut the clamp that secures the inner hinge boot. 3. Using a punch, remove the locking...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: