Removal and installation / check of a sound signal Removal and installation/check of a sound signal Behind a forward bumper on the left side are established on one signal of high and low tone. A relay is...
Remote control initialization The single lock remote control must be installed if the batteries in the key were replaced and the replacement lasted more than one minute, or if a key was...
Replacing incandescent outdoor lighting Incandescent light bulbs wear out over time. Therefore, every two years they must be replaced with new ones, even if they still retain their performance. This...
Replacing incandescent interior lighting Front Dome/Reading Lamp 1. Pry off with a screwdriver and remove the cover -1- forward. To facilitate removal and prevent damage with a screwdriver, it is...
Removal and installation of a headlight Withdrawal 1. Remove, if any, the headlight washer nozzle located under the headlight, refer to Section Removing, installing and checking headlight washer...
Headlight adjustment Proper headlight adjustment is essential for driving safety. Fine adjustment of the headlights is possible only with the use of a special device. Therefore, it...
Dipped beam discharge lamps (xenon lamps) Compared to standard halogen lamps, headlamps with gas discharge lamps (xenon lamps) have a brighter dipped beam similar to daylight. Discharge lamps reach...
Removal and installation of a back lantern Withdrawal 1. Removal of the holder of a lamp of a corresponding back lantern is resulted in the Section Replacing incandescent outdoor lighting . 2. The...