Transmission. General information The gearbox can be removed separately from the engine. Removal is necessary to replace or repair the transmission. Since it is by no means recommended to carry...
Removal and installation of a transmission The instructions for removal and installation do not apply to the gearbox of vehicles with all-wheel drive and the sports gearbox. Withdrawal Raise the car....
Removal and installation of cardan shaft Withdrawal Raise the car. Remove the front and rear mufflers. Remove heat shield (see section « Removal and installation of system of release of the fulfilled...
Transmission maintenance work External inspection of leaks The following leak locations are possible: Connecting the engine block to the gearbox (flywheel gasket/gearbox). Oil filler / oil...
Gear shift mechanism 1 shift lever 2 support 3 Screw 4 Bolt 5 Nut 6 Shift rod 7 Spacer 8 Lock washer 9 Shift rod pivot 10 Roll pin 11 Lubricating felt 12 Spring sleeve 13 Lower...
Removal and installation of the gear lever Withdrawal Switch console made of sheet steel. Raise the car. The cardan shaft with vibration damper must be removed, otherwise it is not possible to remove...
Automatic transmission. general information At the request of the client, BMW models can be equipped with an automatic transmission. The automatic transmission provides automatic shifting in three...
Towing vehicles with automatic transmission Shift Lever Position «N». Maximum towing speed: 50 km/h! Maximum towing range: 50 km! If long distance towing is required, the rear of the vehicle must be...
Automatic transmission: oil level check, oil change Examination Maintaining the correct oil level is essential for proper automatic transmission operation. Therefore, the check should be carried out with...
Change of oil. Cleaning the mesh in the oil sump Usually the ATF oil is changed every 60,000 km, at the same time the screen in the oil pan is cleaned. When the oil in the transmission box is drained, it is...