Car Clutch Repair BMW 7 Series E38

General information about the clutch
The clutch is designed to break the power connection between the engine and the manual transmission when changing gears and, thanks to the friction connection,...

Removal and installation the clutch
1. Remove the manual transmission (see section Removal and installation of manual transmission ). 2. Lock the flywheel from turning using special tool No.11 2...

Replacing the release bearing and clutch release fork
1. Remove the manual transmission (see Removal and installation of manual transmission ). 2. Remove the clutch release sleeve (1). When installing, clean all...

Replacing the clutch master cylinder
1. Drain or pump out the brake fluid until its level reaches the connection point of the clutch hydraulic drive supply line (1). Disconnect the supply line...

Replacing the slave cylinder
1. Remove the lower protective cover of the manual transmission. 2. Plug the hole in the feed line going to the clutch master cylinder using special tool No.13...

Removal and installation the clutch pedal
1. Remove the left lower instrument panel trim panel (see chapter Body ). 2. Remove the clutch pedal position sensor. 3. Remove the retaining clips, press out...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: