Car rear suspension BMW 7 Series E38

Removal and installation the rear suspension beam assembly
1. Remove the rear wheels and propeller shaft (see chapter Cardan and drive shafts, gearbox, differential and hub assemblies ). 2. Pump out the fuel from the...

Removal and installation rear suspension arms and struts
Push Rod/Integral Lever If the integral arm was disconnected from the rocker arm/wheel support during disassembly, the chassis parameters must be measured...

Removal and installation the hub bearing and its support
The procedure for replacing the rear wheel bearing is the same as the corresponding procedure for the front suspension (see section Front suspension ). The...

Removal and installation, disassembly and assembly of suspension strut
The procedure for disassembling and assembling the rear suspension strut is similar to the corresponding procedure for the front suspension (see section Front...

Replacing the EDC control unit
On models from 09.1997, the control unit is installed in front to the right of the instrument panel in front of the glove compartment. On models prior to...

Replacing the hydraulic accumulator
Fastening unit 1 - Bolt (9 Nm) 2 — Washer 3 — Spacer sleeve 4 — Nozzle 1. Remove the wheel arch liner (see chapter Body ), unscrew the pressure relief plug (1)...

Replacing EDC ground clearance sensors
After installing the sensor, check and, if necessary, adjust the headlight inclination (see chapter On-board electrical equipment ). Front sensor 1. Disconnect...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: