Car rear suspension BMW 7 Series E32

Rear suspension. General description
The combined rear axle has a multi-link design with a subframe and double elastic suspension of the main gear. The wheels are guided by four suspension arms,...

Rear shock absorber strut — removal and installation
Early model cars Rear shock absorber strut components 1 - shock absorber; 2 - thrust washer; 3 - top cup; 4 - thrust bearing; 5 - finger; 6 - sealing washer; 7...

Rear suspension assembly — removal and installation
Removal Remove the exhaust system. Remove the driveshaft. Remove the handbrake cable. Pump out the brake fluid from the brake system expansion tank. Disconnect...

Cross beam rubber block — replacement
Removal Remove the rear seat. Support the trailing arm. Remove the thrust rod. Knock the screw pin upwards. Place the shaped washer (A) between the body and...

Trailing arm — removal and installation
Removal Remove the rear wheel. Disconnect the drive shaft from the hub flange and tie it to the body. At the same time, tighten the handbrake. Remove the...

Rear Wheel Bearings — Replacement
Removal Block the front wheels, then jack up the rear of the car and support it securely on axle stands. Disconnect the outer CV joint from the drive flange....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: