Diesel engine M57 car BMW 7 Series E38

Removal and installation of cylinder heads, camshafts and their sprockets
Removal 1. Disconnect the negative cable from the battery. Remove the cylinder head cover. 2. Remove the drive belts (see section Replacing drive belts and...

Removal and installation the upper section of the oil pan
1. Drain the engine oil (see chapter Vehicle settings and routine maintenance ). Remove the crankcase guard. 2. Set the steering wheel to the straight-ahead...

Removal and installation the timing belt cover
1. Remove the oil pan (see section Removal and installation the upper section of the oil pan ) and temporarily install the front axle beam in its original...

Replacing crankshaft seals
It is recommended to use special tools to remove and install the seals. To access the front seal installed in the lower timing chain cover, remove the...

Removal and installation the flywheel
1. Remove the manual transmission together with the clutch or automatic transmission (see chapter Manual gearbox and clutch or Automatic transmission ). 2....

Removal and installation the torsional vibration damper
1. Remove the engine crankcase guard. 2. Remove the generator drive belt. 3. Remove the fan shroud. 4. Install device No.11 6 460 (see fig. illustration ). 5....

Replacing drive belts and their tensioners
Drive belts If you intend to continue using the belt being removed, mark the direction of its movement. 1. Remember the pattern of belt routing on the pulleys....

Removal and installation the oil pump
1. Remove the oil pan (see section Removal and installation the upper section of the oil pan ). 2. Install device No.11 6 460 (see fig. illustration ). 3....

Removal and installation the oil cooler
1. Remove the crankcase guard. 2. Drain the coolant (see chapter Vehicle settings and routine maintenance ). 3. Remove the oil filter housing. When removing...

Removal and installation the intake manifold
After removing the manifold, you should immediately close the intake ports in the cylinder head. If the installed charge air hoses are not degreased or are...

Removal and installation the exhaust manifold
If the installed charge air hoses are not degreased or are damp, this may result in turbocharger failure. 1. Remove the top engine cover and cooling fan...

Removal and installation a vacuum pump
1. Remove the front section of the upper engine cover. 2. Disconnect the vacuum hose (1) from the vacuum pump, unscrew the bolts (2) and onto the vacuum pump....

Removal and installation the engine
If the installed boost air hoses are wet and have traces of grease, this may lead to turbocharger failure. 1. Disconnect the negative cable from the battery....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: