Car manual transmission BMW 7 Series E32

Gearbox. General structure
The gearbox (gearbox) can be removed without removing the engine. Removal is necessary when it is necessary to replace clutch parts or to replace or repair the...

Gearbox — removal and installation
The description below is valid for a manual transmission. Removal Disconnect the ground cable from the battery. Raise and support the vehicle, remove the...

Gearbox housing — removal and installation
Removal Secure the gearbox to the fixture. Pour out the oil. Remove the reverse light switch. Remove the plug and take out the spring and retainer. Remove the...

Primary and secondary shafts — removal and installation
Gearbox shaft elements 1 - retaining ring; 2 - spacer washer; 3 - spacer washer; 4 — bearing; 5 — primary shaft; 6 — synchronizer ring; 7 — needle bearing...

Secondary shaft — replacement
Removal Disconnect the primary shaft with the roller bearing from the secondary shaft. Remove the 5th gear with the needle bearing. Remove the retaining ring....

Gearbox shaft bearings — replacement
Gearbox section Remove the primary and secondary shafts. Primary shaft bearing at the front of the crankcase: knock out the radial bearing with a tool....

Gear Shift Lever — Removal and Installation
Elements of the gear shift mechanism 1 - gear shift lever (inside the cabin); 2 - gear shift lever; 3 - support; 4 — gear shift rod; 5 - spacer washer; 6 —...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: