Car steering BMW 7 Series E38

The principle of operation of the power steering
Design and operating principle of the power steering 1 — Shaft 2 — Torsion 3 - Screw 4, 5 - Spools 6 — Piston 7 - Circulation tube 8 — Shaft with toothed...

Removal and installation the steering wheel, airbag unit and its contact ring
1. Disconnect the negative cable from the battery. 2. Remove two bolts. Do not pinch the cables during installation. Models produced before 03.1999. 1....

Removal and installation steering column covers
Upper casing 1. Set the steering column to its maximum lowered and extended position. 2. Remove the screw. Replace the expansion nut during installation. 3....

Removal and installation the steering column and steering angle sensor assembly
1. Disconnect the negative cable from the battery. 2. Remove the steering wheel (see section Removal and installation the steering wheel, airbag unit and its...

Replacing the steering column adjustment lever
Steering column adjustment lever design 1 - Nut 2 - Bearing 3 - Clamping disc 4 — Retainer 5 - Lever 8 — Torsion spring 9 — Clamping device 1. Remove the upper...

Removal and installation the ignition switch and steering wheel lock
1. Remove the upper steering shaft bearing and the upper steering column cover (see section Removal and installation steering column covers ). 2. Remove the...

Removal and installation of the power steering gear
When replacing the steering gear, check the height of the pendulum arm in relation to the steering shaft. Reusing drained power steering fluid is not allowed....

Removal and installation steering rods, steering knuckle and pendulum arm
Bipod When replacing the steering knuckle, check its installation height in relation to the pendulum arm. 1. Remove the steering gear (see section Removal and...

Removal and installation the power steering pump
Reuse of drained power steering fluid is not permitted. 1. Remove the engine crankcase guard. 2. Remove the power steering pump drive belt (see chapter Engine...

Car Wheel Alignment Angles — General Information
Only the toe-in of the front wheels can be adjusted. The geometry of the suspension and its rigidity determine the ability to limit vertical movements of the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: