BMW 7 Series E38 car automatic transmission

Automatic Transmission Specifications
ATF type and volume cm. Specifications to the Head Vehicle settings and routine maintenance Gear ratios in manual mode AT A5S 310Z (730i models) 1st gear 3.66...

General information about automatic transmission
When starting off, the AT acts as a regular clutch, and when the car is moving, it performs the job of shifting gears. The main components of the AT are:...

Troubleshooting
If a fault is detected in the AT, first check the ATF level (see chapter Vehicle settings and routine maintenance ). If the level is insufficient, check the...

Removal and installation of AT and torque converter
Removal Below is a description using the example of AT A5S 310Z engine M60/1. 1. Disconnect the negative cable from the battery. 2. Remove the exhaust system...

Removal and installation the oil pan
Below is a description using the example of AT A5S 310Z. 1. Remove the ATF drain plug (1) and drain the ATF. 2. Remove the bolts and oil pan. 3. Clean the oil...

Removal and installation the PNP sensor
Below is a description using the example of AT A5S 440Z. 1. Remove the rear engine accessory protection panel. 2. Remove the left and right heat shields. 3....

Removal and installation the ATF filter and hydraulic unit
Below is a description using the example of AT A5S 310Z. 1. Remove the AT oil pan (see section Removal and installation the oil pan ). 2. Unscrew the bolts and...

Removal and installation of electromagnetic valves, regulators and sensors
1. Location of electromagnetic valves, regulators and sensors. 1-5 — Electromagnetic valves 6 — Electromagnetic valve of the torque converter lock-up clutch 7...

Replacing the AT mode switching mechanism bracket
1. Follow the steps described in paragraphs c 4 to 6 Section Removal and installation of AT and torque converter . 2. Remove the selector lever handle by...

Adjusting the shift balancer
1. Set the selector lever (1) to position "P" and loosen the nut (2). 2. To avoid deformation of the cable drive, be sure to hold the unit from turning using...

Adjusting the selector lever
Below is a description for AT A5S 310Z/440Z/560Z. 1. Set the selector lever to position "P". 2. On models before 08.1995 issue. install tool No.24 5 240 on the...

Adjusting and checking the selector lever lock
Adjustment 1. Set the selector lever (1) to position "P" (front shift linkage stop) and loosen the bolt (2). The rod (3) should move easily in the axial...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: