Description of the clutch design Clutch installed on all car models with manual transmission, made by «SAC» (Self Adjusting Ciutch), dry single-disk, self-adjusting, with a central pressure...
Hydraulic clutch system The impact on the master cylinder is a lever (1, fig. 7.4) clutch pedal, which is mounted on its pedal bracket (13). When inspecting the clutch release...
Bleeding the hydraulic clutch One of the main operational operations for clutch maintenance is bleeding the hydraulic system, which is performed after removing any of its elements or...
Removal and installation of clutch Clutch removal must be carried out in the following order. Prepare fixtures «11.9.260», «11.9.263», «11.9.264», «11.9.265». «21.2.141», «21.2.170», «21.2.180»,...
Installing a new clutch Attention! The clutch disc requires careful handling, do not touch the surface of the friction linings. Remove the flywheel retainer only after the clutch...
Clutch Master Cylinder Replacement The main cylinder is fixed on the pedal bracket and the lever of the pedal itself with the pipeline outlet to the engine compartment of the car (see fig. 7.2)....
Replacing the clutch slave cylinder Working cylinder (14, see fig. 7.2) fixed on the crankcase of the manual transmission. It can be accessed from below the vehicle. Depending on the engine...
Replacing the release bearing and clutch release fork Increased noise, when the clutch is turned off, is a characteristic sign of a failed release bearing. Removal of the release bearing and clutch release fork...
Clutch Pedal Replacement Clutch pedal mounted on a single support bracket (13, see fig. 7.4) together with the brake pedal. Removal of the clutch pedal must be carried out without...
Breaking in the SAC clutch Attention! A sporty driving style can damage a new clutch if it has not been run in. After replacing the clutch, it is necessary to break in (earn in) friction...
Clutch tightening torques Clutch housing to engine crankcase (hexagonal) all M8 - 25 Nm; all M10 - 49 Nm; all M12 - 74 Nm. (Torx type) all M8 - 22 Nm; all M10 - 43 Nm; all M12 - 72 Nm....