Transfer box and cardan car BMW X5 E53

Transfer case and cardan shafts — general information
The vehicle's transmission is all-wheel drive (4x4). It is carried out sequentially along the chain: engine - clutch (for manual transmission) - gearbox...

Cardan transmission — design description
The cardan transmission consists of two tubular shafts. The front shaft (2, Fig. 10.23) the 774 mm long driveshaft connects the front axle gearbox to the...

Replacing the driveshaft assembly
Removing the rear wheel cardan drive (fig. 10.25) must be carried out in the following order. Place the car on a lift or ramp and apply the parking brake....

Replacing the flexible coupling of the cardan shaft
The replacement of the flexible coupling of the cardan shaft must be carried out in the following order: Remove the cardan shaft and unscrew the bolts (arrows,...

Replacing the centering element of the cardan shaft
The replacement of the centering element of the cardan shaft must be carried out in the following order. Prepare the tools "00.5.500", "11.1.310" and...

Replacement of constant velocity joint
Removal of the constant velocity joint (CV joint) of the propeller shaft must be carried out in the following order. Prepare the equipment "23.1.040",...

Replacing the front propeller shaft
Attention! After removing the cardan shaft, it is prohibited to start the engine and move the vehicle. The front propeller shaft must be replaced in the...

Replacing the intermediate support of the propeller shaft
The intermediate support is made with a cardan joint, which has a bolted connection. Attention! The cardan shaft is balanced as an assembly. The connecting...

Tightening torques for cardan shaft connections
Flexible coupling to the cardan shaft and gearbox: all M12 (10.9) — 100 Nm. Universal joint with crosspiece to the gearbox: all M10 - 60 Nm. The clamping ring...

Transfer case — design description
On the car with engines "M54", "M62" and "M57" transfer case (RC) model "NV-125", with the engine" N62 "– RC model" ATS500". The full filling capacity of the...

Replacing the output link seal on the front axle
The replacement of the output link seal of the RK type "ATS 500" on the front axle must be carried out in the following order. Prepare the devices "23.0.490"...

Checking the operation of the front axle gearbox and transfer case
Malfunctions in the transfer case and front axle gearbox manifest themselves in complete or partial transmission blocking when cornering, which manifests...

Transfer case replacement
Car with automatic transmission Removal of the transfer case in combination with the automatic transmission must be carried out in the following order. Prepare...

Replacing the axle shaft seal
RK "NV125" The replacement of the axle shaft seal of the RK "NV125" must be carried out in the following order. Prepare the tools "00.5.500", "23.0.490",...

Replacing the output flange seal of the RK
RK type "NV125/LWX-500" Technology for replacing the seal of the outlet flange of the RK type "NV125/LWX-500" for the rear drive, the technology for replacing...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

BMW E53 (1999-2006)