M54 engine power system BMW X5 E53

Safety precautions when working with the fuel system
When working with the fuel system, special care and cleanliness must be observed: do not disconnect the battery pack (AB) while the engine is running; before...

Air supply system — general information
The air supply system is designed to supply air to the combustion chamber in the amount required by the engine at a given power level, while maintaining...

Air filter — design description
Fence device (suction pipe) plays an additional role as a muffler for air intake noise and is connected to the air filter housing by a corrugated casing. Air...

Intake manifold — design description
The intake manifold (23) is a system of air channels that connects the intake ports of the engine cylinder head with the throttle body pipeline (Fig. 3.18). 1...

Fuel Supply System — Design Description
The fuel supply system (Fig. 3.19) is designed to supply such a quantity of fuel to the combustion chamber that ensures complete combustion of the fuel, a...

Fuel tank — design description
The saddle-type fuel tank is designed for filling and storing the required supply of fuel during vehicle operation. Plastic fuel tank (1, Fig. 3.20)...

Fuel pump — design description
The fuel pump is a rotary, submersible type with an electric drive, manufactured by Bosch (Germany), and is installed in the right half of the fuel tank. The...

Fuel filter — design description
Fuel filter with pressure regulator (1, Fig. 3.21) installed on the pipeline after the fuel pumps and secured with a clamp (5). The fuel filter housing...

Fuel level indicator sensor
The fuel level indicator sensors are lever-type and each half of the fuel tank has its own sensor. The right lever sensor is built into the fuel supply unit,...

Checking the fuel supply pressure
The fuel pump supplies fuel in greater quantities and under greater pressure than is necessary in the most powerful mode. Excess fuel is discharged through the...

Analysis of engine operation and measurement results
If the engine dynamics are impaired, there is not enough power, then it is necessary to start the engine and bring it to idle mode. Measure the fuel supply...

Replacing the intake manifold
Attention! When carrying out work on fuel pipelines, ensure that leaking fuel is collected and disposed of. Removing the intake manifold(23, see Fig. 3.18)...

Replacing the air filter element
The replacement of the replaceable air filter element must be carried out in the following order. Open the clamps (7, see Fig. 3.18) air filter housing covers...

Replacing the fuel tank ventilation valve
The fuel supply system pipes and fuel tank are shown in Fig. 3.20. 1 - fuel tank; 2 - supply pipeline; 3 - drain pipe; 4 - pipelines; 5, 19 - clamp; 6 - clamp;...

Removal the fuel tank
Attention! After installing the fuel tank, before the first start of the engine, measure the electrical resistance between the ground flag (at the filler neck...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

BMW E53 (1999-2006)