Caution! The driven clutch disc requires careful handling; do not touch the surface of the friction linings.
Remove the flywheel retainer only after the clutch mounting bolts are fully tightened.
The installation of a new clutch should be carried out in a similar manner, but it is necessary to take into account the following features.
Center the slave disk (1, see Fig. 7.13) clutch using the devices specified earlier for manual transmission models.
Install the clutch basket on the centering pins protruding from the flywheel and screw in the mounting bolts. Tighten the clutch housing mounting bolts as indicated above.
Attention! Retainer (1, Fig. 7.16) can only be removed after the clutch mounting bolts have been tightened.
Carefully unscrew the retainer (1, Fig. 7.16) using a 14 mm Allen key (2), turning it clockwise or counterclockwise. When unscrewing the lock, a slight click of the disc spring may be heard.