Withdrawal
Apply paint marks that determine the relative position of the front and rear shafts in order to connect them during assembly in the same position and keep the balance of the rear shaft unchanged.
Depending on the version, remove the locking ring or unscrew the nut securing the front propeller shaft yoke and separate the front and rear propeller shafts.
Having brought the levers of the universal puller under the dust deflector, remove the intermediate support complete with the bearing and the dust deflector from the front shaft, then press the bearing out of the support.
Installation
Press the bearing into the new bearing with a mandrel, having previously lubricated the bearing seat with soapy water.
Using drift 241050, press the intermediate bearing onto the rear end of the front shaft.
Connect the front and rear propeller shafts, while depending on the version, install the locking ring or tighten the front shaft yoke nut, having previously applied Loctite 270 to the threads.