Withdrawal
Remove the hand brake lever.
Remove the handbrake pad lock.
Disconnect the handbrake cable from the rear axle rocker arm and pull the cable out of the protective tube.
Loosen the handbrake cable support and pull out the cable.
Installation
Route the cable to the handbrake lever and to the rear wheel brake.
Attention: When installing in a protective tube, make sure that the support for the cable sheath rests on the tube.
Connect the handbrake cable to the rear axle rocker with a plastic clamp.
Insert the cable support and fix it with 2 bolts on the brake shield.
Assemble the drum brake.
Install the handbrake lever.
Adjust handbrake.