Withdrawal
Raise the rubber boot on the handbrake lever and pull it back.
Loosen the handbrake cable nuts.
Remove the rear drum brake pads.
Remove the handbrake cable from the trailing arm.
Compress retaining clip -1- with pliers and pull handbrake cable back out of brake shield -2-.
Installation
Route the handbrake cable to the handbrake lever and to the brake shield.
Insert the run brake cable into the retaining clip on the brake shield. Make sure the locking bracket is in the correct position.
Attach the handbrake cable to the trailing arm.
Assemble the drum brake.
Screw on the handbrake cable nuts.
Adjust handbrake.
Put the rubber boot on the handbrake lever.