Withdrawal
Remove the hand brake lever.
Remove parking brake pads
Remove the spacer lock of the hand brake pads by depressing pin 1 for this.
Unscrew the handbrake cable sheath support, for which unscrew bolts 2.
Disconnect the handbrake cable from the trailing arm of the rear axle and pull the cable out of the protective tube.
Installation
Route the cable to the handbrake lever and to the rear wheel brake.
Attention: When installing in a protective cover, take into account that the support for the cable sheath is adjacent to the tube.
Connect the handbrake cable to the rear axle rocker with a plastic clamp.
Insert cable support and fasten it with 2 bolts 2 to the brake shield.
Assemble the drum brake.
Install the handbrake lever.
Adjust handbrake.