Car windscreen wipers and washers BMW 5 Series E39

Windscreen wiper system — general information
The windshield wiper drive is located in the water drainage casing under the windshield. The windshield wiper system, like the windshield washer system, is...

Replacing the rubber band of the windshield wiper blade
If the window glass is not cleaned well, the rubber strips of the windshield wipers must be replaced with new ones. In specialized stores, you can buy rubber...

Removal and installation / adjustment of windshield washer nozzles
Removal Open the engine compartment hood. Release and fold up the lower part of the hood trim. To do this, unscrew the plastic screws "1" from the clamps "2",...

Adjusting the rear window washer nozzle (Touring)
The nozzle jet should hit the center of the designated field. A - about 10 cm; B - approximately 5.5...6.0 cm. Caution: When adjusting, do not insert any sharp...

Removal and installation the rear window washer nozzle (Touring)
Removal Remove the antenna amplifier . Remove the rubber insert for the washer fluid hose on the right next to the antenna amplifier. Disconnect the washer...

Windscreen wiper motor/drive
1 - Windscreen wiper console 2 - bolt 3 - windshield wiper motor 4 - electric motor crank 5 - Hexagon head bolt 6 - bearing sleeve with groove 7 - bearing...

Removal and installation the windshield wiper drive/cowl cover
Removal Mark the position of the wipers on the windshield using adhesive tape. To do this, stick a strip of adhesive tape to the glass directly next to the...

Removal and installation the windshield wiper drive motor
Removal Remove the windshield wiper drive. Unscrew nut "5" securing crank "4" to the windshield wiper motor axle. Unscrew the 3 bolts "6" securing the electric...

Removal and installation the rear window wiper motor (Touring)
Note: Installation requires special tool BMW-611320. Removal Remove the rear door trim. Disconnect 2 plugs "1" for electrical wires from the electric motor....

Removal and installation the rear window wiper shaft bearing (Touring)
Application: special tool BMW-611320 is required for installation. Removal Remove the rear window wiper arm, see next chapter. Loosen the nut on the electric...

Removal and installation the rear window wiper arm (Touring)
Removal Bring the windshield wiper lever to its original position. To do this, wet the rear window with water, briefly turn the windshield wiper on and off via...

Window glass washing system device
1 - filler cap 2 - grid 3 - filling pipe 4 - washer fluid reservoir insert 5 - plastic nut 6 - washer fluid reservoir 7 - windshield washer pump 8 - sealing...

Checking/replacing the windshield washer pump
Note: Checking the windshield washer pump motor is described here . Removal Disconnect the plug Drain the washer fluid from the reservoir. Remove the pump from...

Diagnosing Wiper Blade Rubber Band Faults

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: