Car transmission line BMW 5 Series E28

General information about the transmission line
General information This Chapter describes the components that transmit rotation from the gearbox to the drive wheels of the vehicle. These components include...

Removal and installation the propeller shaft
Removal 1. Block the front wheels, then jack up the rear of the vehicle and secure it on axle stands. Remove the exhaust system (see chapter Exhaust system )....

Checking the operation and replacing the elastic coupling
Examination Although BMW does not specify specific inspection intervals for the flexible coupling located between the front section of the driveshaft and the...

Checking and replacing the center bearing
Examination The center bearing consists of a ball bearing assembly surrounded by a rubber cushion. The bearing assembly is pressed onto the rear end of the...

Checking and replacing cardan joints
Examination Wear of cardan joints is accompanied by vibration in the transmission, noise during acceleration and a sharp metallic grinding sound when the...

Checking and replacing the front centering guide
Examination The front centering guide ensures the unique installation of the cardan shaft in relation to the transmission flange. The guide, which is pressed...

Replacing the constant velocity joint of the cardan shaft
The constant velocity joint (CV joint) on the front of the driveshaft on some models is bolted directly to the transmission flange. Replacing it requires...

Removal and installation drive shafts
Removal 1. Set the parking brake. Loosen the rear wheel mounting bolts, but do not remove them yet. Jack up the rear of the vehicle and securely support it on...

Checking and replacing CV joints and their protective covers
Some automotive dealers supply replacement "split" type boot covers that can be installed without removing the drive shaft from the vehicle (they wrap easily...

Replacing the side seals of the differential housing
1. Jack up the rear of the vehicle and securely place it on axle supports. 2. Drain the differential lubricating fluid (see chapter Routine car maintenance )....

Removal and installation the differential housing
Removal 1. Jack up the rear of the vehicle and secure it on axle stands. Drain the differential fluid (see chapter Routine car maintenance ). 2. Disconnect the...

Replacing the gear seal
1. Jack up the rear of the vehicle and securely place it on axle supports. 2. Remove the differential cover (see section Removal and installation the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: