Brake system of the car BMW 5 Series E28

General information about the brake system
All E28 models (with the "retro" body) are equipped with disc brakes at the front, and either drum or disc brakes at the rear. E34 models (with a modern body)...

General information about anti-lock braking system
The anti-lock braking system is designed to ensure the vehicle's maneuverability, its stability on the road and the optimal braking mode in difficult road...

Replacing disc brake pads
Disc brake pads must be replaced on both wheels at the same time - NEVER replace the pads on just one wheel. In addition, the dust created by the brake system...

Removal, major repair and installation of the disc brake caliper
Rear Brake Caliper Assembly Components (for the front wheels the same) 1 - Assembling the caliper 2 — Bracket mounting bolt 3 — Bleed valve 4 - Dust cap 5 -...

Inspection, removal and installation of the brake disc
This procedure applies to both front and rear brake discs. Brake discs should always be replaced or repaired in pairs (both front or both rear discs), even if...

Replacement of brake drum shoes
The brake shoes must be replaced on both wheels at the same time - never replace the shoes on just one wheel. In addition, dust that collects on the brake...

Removal and installation the master brake cylinder
Brake fluid is poisonous. It is also a strong paint solvent. See Warning in Section Bleeding the hydraulic brake system . Although there are parts and a master...

Checking the condition, removing and installing the brake booster
Components of a typical vacuum booster pushrod assembly 1 - Protective case 2 - Holder 3 — Shock absorber 4 - Air filter Checking the work 1. With the engine...

Description, removal and installation of the brake system vacuum hydraulic booster
Brake fluid is poisonous. It is also a strong paint solvent. See Warning at the beginning of Section Bleeding the hydraulic brake system . Description On E28...

Replacing the parking brake cable(s)
1. Bend back the boot at the base of the parking brake lever and remove the parking brake cable adjustment nut, which also holds the cable to the brake lever...

Adjusting the parking brake
Models with rear drum brakes Adjustment of the parking brake cable(s) on models with rear drum brakes may only be necessary if you are replacing the cable or...

Checking the condition, removing and installing the parking brake assembly
Parking brake shoe linings on models with rear disc brakes may be made from asbestos-containing materials. Please refer to the Warning at the beginning of this...

Adjusting the brake pedal
After replacing or removing the master cylinder or brake booster, you should always adjust the brake pedal height. At the same time, you should also adjust the...

Checking and adjusting the brake light switch
The brake light switch should be checked and adjusted if necessary after replacing or removing the master cylinder or vacuum booster. The switch is located on...

Inspection and replacement of brake lines and hoses of the hydraulic brake system
Brake fluid is poisonous. It is also a strong paint solvent. See Warning at the beginning of Section Bleeding the hydraulic brake system . Inspection At...

Bleeding the hydraulic brake system
When bleeding the brake system, wear safety glasses. If fluid does get into your eyes, rinse them immediately with water and seek medical attention. Most types...

Diagnostics of brake system faults
Before concluding that the brake system has failed, check the condition and inflation pressure of the tires and the uniformity of the vehicle loading (see...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: