Attention: When applying a protective agent on the bottom of the car, cover the lambda probe.
Withdrawal
Disconnect the lambda probe connector by turning the knurled nut to the left. The connector is located on the gearbox beam.
Loosen the wire harness.
Unscrew the lambda probe. At the same time, turn the wire by hand to avoid breaking it.
Installation
Caution: Do not clean the lambda probe and do not allow it to come into contact with lubricants.
Lubricate only the threads of the lambda probe with grease "Antiseize".
Screw lambda probe into front exhaust pipe and tighten to 5 Nm.
Fasten the wire.
Secure the lambda probe connector with the rivet nut.