Pull the seat cushion by the loop and set it upright, if necessary, move the front seat forward a little.
The rear seat backrest is automatically released and can be folded forward.
The outer corner parts of the support pads are fixed.
Before doing this, pull out the head restraints with a jerk, tilting the seat if necessary.
The head restraint can be folded into the space between the backrest folded forward and the door.
If you accidentally lock the seat back, press the lever (arrow) - releasing the lever will unlock the backrest.
If necessary, the seat cushions can be removed. To do this, install them vertically, squeeze the release levers and pull them up. Proceed in reverse order during installation.
If you want to have enough space for loading bulky items, then to do this, move the right front seat forward, pull out the head restraint (electric headrest - jerk) and fold back the seat.
To secure the electrically operated head restraint when reinstalling, press firmly on it.
After dismantling the seat cushion, turn up the bracket (arrow) and secure the red latch of the seat back to the bracket pin.
Fold the bracket down before installing the seat cushion!
Please make sure that the cargo is securely fastened and cannot move during movement; when braking and maneuvering, there should be no danger to passengers.
To ensure the correct functioning of the seat belts, make sure that the latch fully engages when the seatback is returned to its original position. Red heck (arrow) should move down.
When the seat back is not fixed, the seat belt cannot be pulled out.
BMW Touring
Reclining rear seat back
The back of the rear seat is divided into two parts in the ratio of 1/3 to 2/3. To recline, press the button (above) and lay the back completely down.
To return to the original position, press the button again.
Protective curtains of a cargo compartment
Pull out the curtains and fix them at the back.
The shutter cassette can be dismantled. To do this, press the buttons on both sides and remove the cassette.
To remount the cassette, simply push it into the mounts.
Dividing grid of a cargo compartment
Pull the net out of the larger upper part of the seatback, extend the mounting bar to its full width and hang it on the holders.
If desired, instead of the larger one, you can pull out the smaller part of the net and hang it on the mounting bar.
Tie-down bar holders are available for both the reclined and upright rear seat backrests.
Hinged covers on the bottom of the cargo compartment
Opening - press the grip recess at the back and flip the lid up.
Under the front flap are: a car jack, a wrench for wheel bolts, a thrust wedge, a head for "secrets" wheels*, a hex wrench for the protective cover of the wheel bolts*, as well as a ball head for the towing device*.
Under the rear flap are: a spare wheel and a box with compartments.
Side trim of the cargo compartment of the body - opens by pressing the release button in the upper left corner of the trim.