Removal and installation the front bumper (BMW 3 Series E30)

Removal

Loosen the "2" bumper mounting bolts in the wheel arches on each side.



Using a screwdriver, press the protective caps (arrow) from each side of the bumper profile and unscrew the bolts -1-. At the same time, an assistant should hold the bumper.



Disconnect the turn signal connectors on both sides.





If it is necessary to replace the bumper cover, squeeze the locking hooks of all cover clamps. Remove the bumper profile. When installing, replace the cover clamps. Insert a screwdriver into the clamp and insert the clamp into the bumper.

Installation

If the turn signals have been replaced, pay attention to their installation position. The housings of the turn signal lamps are marked R (right) or L (left).

Connect the turn signal connectors.

With the help of an assistant, place the bumper in a horizontal position.

Screw 2 bolts into the beam from the front without tightening them.

Tighten one bumper mounting bolt in each wheel arch.

Tighten both front nuts "1" of the bumper and put on the protective caps.



Check the operation of the direction indicators.