Align the hood of the engine compartment with the side walls in front and on the sides.
Make an exhibition in height. To do this, loosen bolts -1- and -2- on both sides and move the bonnet up or down.
The hood of the engine compartment must be set in height so that it is located approximately 1 mm below the side walls (front fenders).
Adjust the guide roller at the rear of the hood. To do this, loosen the screws.
Move the bracket with the roller so that the roller slides flawlessly into the latch. Observe the clearance between the side wall and the hood of the engine compartment.
Loosen bolts -1- and -2-. Align the latch so that in the closed position the engine compartment hood is flush with the side wall.
Unscrew the buffers so that they are slightly pressed by the hood and the hood of the engine compartment is flush with the side wall.