Withdrawal
On vehicles with a trim on the trunk, remove the trim.
Fold out the luggage compartment carpet.
Raise the lower trim slightly and pull it out.
Loosen the 3 lock screws on the luggage compartment side. Hold the lock cylinder from the outside so that it does not fall.
On vehicles with central locking system: Detach connecting rod -A- from control motor.
Pull the lock out to the side.
Removing the lock cylinder
Loosen the retaining ring on the lock cylinder with a screwdriver. Pull out the lock cylinder.
Installing the lock cylinder
Insert the lock cylinder into the mount. Insert retaining ring. Ensure correct seating of retaining ring in groove.
Installation
Insert the lock, holding the lock cylinder from the outside.
Fasten the lock with 3 screws. Don't forget to put on the gasket.
On vehicles with a central locking system: connect the tie rod to the actuator motor and then insert it into the lock cylinder. To do this, turn the plastic clip so that the notch points downwards. Then insert the connecting rod with a screwdriver.
Check the functioning of the lock and the central locking system.
Install luggage compartment trim.
On vehicles with boot trim: install trim.