Remove the shield (1, Fig. 18.45) outside door handle. Pull (A) the shield (1) back by approximately 1–2 mm. Pull (B) the shield (1) together with the lock cylinder (2) outward.
Release the clamps (1, Fig. 18.46) and disconnect the shield (2) from the lock cylinder (3).
The installation of the lock cylinder assembly should be carried out in the reverse order, while it is necessary to prevent damage to the lock cylinder (3) and the clamps (1) of the shield (2).
Slot (2, Fig. 18.47) the blade fastening (1) must be installed in the retainer (3). Only in this position is the installation of the lock cylinder ensured.
Place a new plug on the end of the door.