Withdrawal
Loosen wheel bolts.
Raise the front of the car, remove the wheel.
Loosen the steering knuckle nut. Press out the steering knuckle joint with a suitable puller.
Release the tie rod end clamp while holding the tie rod with a 17 mm wrench.
Loosen the steering knuckle.
Attention: When unscrewing, note the number of turns.
Installation
Screw on the steering knuckle the same number of turns.
Insert the tie rod into the steering linkage arm. Screw in a new self-locking nut with a tightening torque of 35 Nm.
Put the wheel on.
Lower the car.
Tighten wheel bolts crosswise to 110 Nm.
Adjust convergence.
Tighten the steering knuckle to 15 Nm.