Installation
Remove the rag, place the carburetor on the insulating flange and tighten the mounting screws with a tightening torque of 10 Nm.
Connect the fuel hose and secure it with a clamp.
Connect the electrical wires to the throttle control, potentiometer and choke control and secure the connectors with clamps.
Connect and secure the idle speed switch connector with a clamp.
Install the throttle cable (see section "Adjusting the throttle cable").
Connect the vacuum hoses according to the hose routing diagram on the carburetor.
Install the air filter (see section "Removal and installation the air filter").
Connect the ground wire to the battery.
Check and, if necessary, adjust the idle speed and CO content.
The 2BE carburetor has been installed on BMW 316 models produced since September 1983.
1 Air damper
2 Float chamber, 1st stage
3 Throttle valve assembly
4 Executive lever
5 Gas cable
6 Air filter mounting bolt
7 Throttle control
8 Idle speed switch connector
9 Float chamber, 2nd stage
10 Vacuum membrane, 2nd stage
11 Fuel supply hose nipple
12 Carburetor cover
13 Air damper regulator
14 Throttle position potentiometer
15 To temperature valve