Withdrawal
Open glove box.
Use a narrow screwdriver to pry up the fixing straps and remove the straps.
Pull the locks on the left and right of the glove box axle down and disconnect them (lock removed).
Remove glove box.
If the console or heater needs to be removed, the glove box inner lining must be removed. To do this, loosen the screw (1) and pull the lining out of the hooks up.
Installation
Install the interior lining. Place the glove box with the locks inserted on the axle, do not close the locks yet.
Close the glove box and move it to align it (gaps on the left and right should be parallel and the same). Close locks. Open glove box and close again. Repeat the adjustment if necessary.
Put on the fastening tapes and fasten them with clips.