The design of the glove box is shown in Figure 18.93. Removing the glove box must be carried out in the following order. Remove the lower right instrument panel trim and open the glove box. Remove the glove box lamp cover and disconnect the loop.
Raise the print box (1, fig. 18.94) and unplug the pin (2) from the retaining tape (3). Pry up and fully open the glove box lid.
Remove screws (1 and 2, fig. 18.95) box fixings. Remove the screw (3) and lower the glove box.
Disconnect the charging loop of the portable lamp.
Unhook the wire (2, fig. 18.96) from holder (3) and remove the glove box.
Installing the glove box should be done in reverse order.