Withdrawal
Set the seat to its highest position.
Move the seat forward to access the rear bolts.
Attention: In case of failure of the electric drive, the seat can be moved manually by inserting into the opening of the drive (in front under the seat, next to the right rail) screwdriver 4 mm wide and turning it.
Remove 2 bolts -arrows-. This requires an E14 Torx key.
Disconnect the height adjustment cable from the underside of the seat. To disconnect, tilt the lock in the direction of the arrow down (The figure shows the attachment with the guide roller when the seat is removed).
Raise the seat at the rear and slide forward from the retaining brackets.
Disconnect the electrical connectors and pull out the seat.
Attention: For safety reasons, the dismantling of the seat must be carried out at a service station.
Installation
Insert the seat, connect the connectors.
Slide the seat back under the front retaining brackets.
Tighten the 2 rear Torx bolts of the guide rails with a tightening torque of 60 Nm.
Attach the seat height adjustment cable. Press the latch against the direction of the arrow and click into place.
Check the installation of seat belts, the movement of the seat, as well as the electric drive.