Electric outside mirror
A switch is used to adjust the mirror.
Electrical heating*
Heating is switched on and regulated automatically at the key position (2).
Right exterior mirror
The position of this mirror can be adjusted using the mirror switch after pressing the select button.
Attention: Usually a convex mirror is installed on the right. The outer part provides a larger field of view than the inner part. This increases the angle of view and, if properly installed, eliminates the so-called "dead zones".
But it should be remembered that the actual distance to the object reflected in the mirror is less than it seems. It takes some skill to judge the distance correctly. This also applies to the mirror farthest from the driver.
Manual mirror adjustment
The position of the mirror can be changed by pressing on the edge of the glass.
Aspherical wide-angle mirror
The outer, spherical part provides a larger field of view than the inner, conventional part of the mirror. This increases the angle of view and, if properly installed, eliminates the so-called "dead zones".
Rear-view mirror in saloon
To reduce the blinding effect of the headlights of cars driving behind at night, you need to move a small lever from below.
Anti-dazzle interior rear view mirror
The reflectivity of the mirror can be adjusted depending on the brightness of the ambient light and the glare of the headlights of the vehicles behind, using the lever.
- middle position (with fixation): normal sensitivity.
- Shift to the left: reduced sensitivity.
- Far left: Disable automatic reflectivity correction.
- Shift to the right: increased sensitivity.
- Far right: Automatic reflectivity correction is on all the time.
Green light on when automatic reflectivity correction is enabled (Light-emitting diode).