Withdrawal
Remove the wheel hub.
Having pressed out an epiploon, press out from a nave internal rings of bearings.
Press out the outer races of the bearings with a puller 00 8 550 or knock them out by inserting a mandrel into the slots in the hub.
Installation
Press new bearings into the hub, pre-lubricated, on a press using a mandrel in the following sequence:
- the outer ring of the outer bearing;
- the inner ring of the outer bearing;
- the outer ring of the inner bearing;
- the inner ring of the inner bearing.
Fill the space between the working edges of the new oil seal with graphite grease and press the oil seal into the hub so that its end is in the same plane with the surface of the hub.
Install the hub and adjust the clearance in the hub bearings.