Remove the oil filter cover with the center bolt.
Wait for the oil to drain from the filter housing. Then pull out the filter element. Wipe off drops of oil with a cloth.
Insert a new filter element into the oil filter housing.
Caution: Observe the instructions printed on the oil filter.
Clean the oil filter cover, replace the rubber o-rings (arrows) on the center bolt and on the cover and lubricate them with engine oil.
Insert the oil filter cover with the central bolt evenly from above and press down. This will engage the central bolt in the corresponding threaded hole in the filter base.
Tighten the central bolt to 25 Nm.
Oil filter change, screw cap design
Unscrew the screw cap using a 36 mm socket. In specialized workshops, a special tool is used for unscrewing, which is put on the outer part of the cover.
Wait for the oil to drain from the filter housing. Then pull out the filter element.
Insert a new filter element into the oil filter housing.
Install the rubber o-rings on the oil line and cap and lubricate them with engine oil.
Insert the oil filter cover with the oil line evenly from above and press it down. In this case, the oil line will enter the corresponding hole in the base of the filter.
Tighten the oil filter cap to 25 Nm.