Removal and installation the lateral acceleration and vertical axis rotation sensor of the DSC system
Caution: Observe the ESD protection instructions (ESD - Electrostatic Discharge).
1. Remove the compartment for small items.
2. Disconnect the connector (1).
Note: When installing, make sure the connector is securely fastened.
3. Loosen the screws (2) and remove the sensor.
Tightening torque: 8 Nm.
4. Installation should be carried out in the reverse order of removal, taking into account the above notes.
5. Perform DSC sensor correction.
(The original article is posted on the resource: «bmwman»)