Replacing the rear pulse sensor
Caution: Observe the ESD protection instructions (ESD - Electrostatic Discharge).
1. Loosen the screws (1).
2. Remove the expansion rivet (2) and remove the cover (3).
3. Open the plug housing (1) of the connector.
4. Remove the sensor connector from the mount and disconnect.
5. Disconnect the wire holders along the trailing arm.
6. Remove the Allen screw (1). Remove the sensor (2) from the hole.
7. Clean the hole for the pulse sensor and lubricate it with Staburags NBU 12/K grease.
Tightening torque: 8 Nm.
8. Installation should be carried out in the reverse order of removal, taking into account the above notes.