Drive shafts and axles of car BMW X3 E83

Drive shafts and axles — equipment and tools
Drawing Name and code 230020 Anti-rotation device 315130 Mandrel kit 331150 device 332110-332119 Pressing and pressing tool 332160 Expansion washer 335070...

Changing the oil in the front axle gearbox
Caution: Risk of poisoning if oil is ingested. Risk of injury if oil comes into contact with eyes or skin. Attention: Only certified grades of oil must be used...

Checking the oil level in the rear axle gearbox and bringing it up to standard
Caution: To avoid serious damage to the rear axle differential, only use the recommended oil. 1. Unscrew the plug (1) of the oil filler hole. 2. Check the...

Rear axle gearbox oil change including waste oil disposal
Caution: To avoid serious damage to the rear axle differential, only use the recommended oil. Note: The rear axle gearboxes have a sticker "Ufe-Time-Oil" the...

Front axle gearbox
Removal and installation the front axle gearbox 1. Remove the front panel of the unit protection. 2. Drain the oil from the front axle gearbox. 3. Remove the...

Front axle gearbox input shaft flange seal
Replacing the front axle input shaft flange seal 1. Remove the stiffener plate. 2. Remove the front propeller shaft. 3. Mark the position of the nut relative...

Left axle shaft seal
Replacing the left axle shaft seal 1. Remove the left axle shaft. 2. Remove the oil seal (1) from the transfer case (3) using a suitable screwdriver (2). Note:...

Right axle shaft seal
Replacing the right axle shaft seal 1. Remove the right axle shaft. 2. Remove the oil seal (1) from the support bracket (3) by prying it with a screwdriver...

Pressing out the axle shaft from the flange (wheel hub) and pressing it back in
Caution: Do not press in or out the axle shaft using an impact wrench. Caution: To avoid damage to the axle shaft and adjacent components, it is necessary to...

Half shaft — removal and installation of the left or right half shaft
1. Remove the front wheel. Caution: Spread the angular locking device wide enough to avoid damaging the threads when loosening the flange nut. 2. Loosen the...

Rear axle gearbox
Removal and installation the rear axle gearbox Caution: Use only recommended rear axle gearbox oils. Attention: Install the spacer washer (1) in place. In the...

Main gear drive flange oil seal
Replacing the main gear pinion flange seal Caution: Use only recommended rear axle gearbox oils. 1. Disconnect the cardan shaft from the main transmission...

Pressing out and pressing in the axle shaft into the flange (the axle shaft is disconnected from the rear axle gearbox)
Note: The operations for pressing out and pressing into the flange of the rear axle half-shaft are similar to the operations for pressing out and pressing into...

Right axle shaft
Removal and installation the right axle shaft 1. Remove the rear wheel. Caution: Spread the angular locking device wide enough to avoid damaging the threads...

Left axle shaft
Removal and installation the left axle shaft Caution: The following procedures should only be performed on a cooled vehicle. 1. Completely remove the exhaust...

Cardan shaft (universal joint with crosspiece) assembly
Removal and installation the propeller shaft (universal joint with crosspiece) assembled 1. Remove the exhaust system assembly. 2. Remove the heat-insulating...

Flexible coupling of the cardan shaft
Removal and installation the flexible coupling of the cardan shaft 1. Disconnect the propeller shaft from the gearbox and intermediate support. Note: To...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: