Diesel engine «M47 T2» of car BMW X3 E83

Equipment and tools
Drawing Name and code 002530 Measuring bridge 009120 Measuring disc 115180 Locking pin, with bend 135020 Key, solution 17 000200 Traverse 113340 Locking pin...

Cylinder head
Removal and installation the cylinder head Attention: Replace the cylinder head bolts. Do not wash off the coating from the bolts. There should be no coolant,...

Oil sump
Removal and installation the oil pan 1. Secure the engine to the assembly stand. 2. Lower the front axle. 3. Drain the engine oil 4. Unscrew the oil pan...

Lower timing belt cover
Removal and installation the lower timing belt cover Attention: When working with oil, fuel and coolant circuits, the generator must be protected from...

Generator drive belt
Removal and installation the alternator drive belt Note: If the drive belt is to be used in the future: mark the direction of movement. put the drive belt back...

Air conditioning compressor drive belt
Removal and installation/replacing the drive belt (elastic) air conditioning compressor 1. Remove the front engine crankcase protection panel. 2. If necessary,...

Gas distribution mechanism
Removal and installation camshafts 1. Remove the vacuum pump. 2. Remove the cylinder head cover. 3. Turn the engine crankshaft using the central bolt. Note:...

Adjusting the valve timing
1. Remove the cylinder head cover. 2. The camshaft cams of the intake valves of the 1st cylinder are facing downwards. 3. Unscrew the bolt (1). Note: First,...

Pistons — removal and installation
Note: Engine removed. 1. Remove the cylinder head. 2. Remove the oil pan. 3. Remove balance weights/oil pump. Note: When installing, tighten the bolts...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: