Attention: When performing repair work on the brake system, it is necessary to follow the sequence of actions in accordance with the section "Bleeding the brake system with DSC".
1. Connect the brake fluid replacement device to the reservoir and turn it on.
Note: Follow the operating instructions provided by the device manufacturer.
2. Connect one end of the hose to a receiving vessel, and place the other end on the head of the nipple of the rear right wheel caliper.
3. Loosen the nipple and bleed the hydraulic drive until clean brake fluid without air bubbles flows out.
4. Close the nipple.
5. Repeat the operation on the rear left, front right and front left wheels.
Note: For vehicles with manual transmission, it is necessary to additionally flush the clutch slave cylinder.
6. Turn off the brake fluid changer and disconnect it from the reservoir.
7. Check the brake fluid level. If necessary, add/pump out fluid up to the MAX mark.
8. Close the tank.
Note: Make sure the rubber gasket (1) is in place in the lid.