Removal and installation the fog light and rear fog light switch (BMW 3 Series E36)

Removal

Disconnect the ground wire from the battery.

Caution: When the battery is disconnected, the information in the electronic memory devices, such as the engine fault memory or the radio security code memory, is erased. Disconnect the battery only when the ignition is off, so as not to damage the fuel injection system control unit. When disconnecting the battery, follow the instructions in the sections "Radio" and "Removing and installing the battery".

Remove the driver's side footwell trim.

(Figure W 5870) Squeeze the lock "4" and pull out the switch.

Disconnect the connector.

Installation

Connect and secure the connector.

Insert the switch from the front into the hole and fix it.

Connect the ground wire to the battery.

Attention: Connect the battery with the ignition off, otherwise the electronic control unit of the injection device may be damaged.

Check the operation of the switch.

Set the time on the clock.

Set the security code for the radio receiver, see section "Setting the radio receiver code".

Install the driver's side footwell trim.