Withdrawal
Disconnect the ground wire from the battery.
Attention: When the battery is disconnected, the information in the electronic memory devices, such as the engine trouble memory or the radio security code memory, is erased. Disconnect the battery only when the ignition is switched off, so as not to damage the fuel injection system control unit. When disconnecting the battery, follow the instructions in sections "Radio" And "Removing and installing the battery".
Attention: On vehicles with a six-cylinder engine, the battery is located in the luggage compartment on the right side next to the spare wheel.
Remove the footwell trim on the driver's side.
Unscrew the lower trim of the steering column, loosen the sides from the upper trim and remove.
Loosen the screws on both sides.
Pull out the switch.
Disconnect connector.
Installation
Connect and secure the connector.
Insert and lock the switch.
Tighten the screws, locking them with paint.
Connect on the sides and screw on the lower trim of the steering column.
Connect ground wire to battery.
Attention: Connect the battery with the ignition off, otherwise the electronic control unit of the injection device may fail.
Check switch operation.
Set clock time.
Set radio security code, see section "Setting the radio code".