Withdrawal
1. Remove the brake lever, refer to the appropriate section.
2. Remove the parking brake pads, refer to the appropriate section.
3. Remove the brake shoe lock, to do this, remove the pin -1-.
4. Turn away bolts -3- and remove a support of a cable of a brake.
5. Disconnect the cable and pull it out of the protective tube.
Installation
1. Route the cable to the brake lever and to the rear brake.
When inserting the cable into the protective tube, make sure that the cable support rests against the protective tube.
2. Connect the cable to the plastic clip.
3. Insert the cable support into the cable and fasten it to the brake shield with two bolts -2-.
4. Assemble the parking brake, refer to Section Removal and installation of parking brake pads.
5. Install the brake lever, refer to the appropriate section.
6. Adjust the brake, refer to the appropriate section.