2. Measure the length of the tie rod and record the measurement, or paint a mark on the thread to ensure the tip is in the same position when reassembling. Loosen the clamp bolt.
3. Using a ball joint remover or puller, separate the tie rod end from the steering arm.
4. Unscrew the steering rod end.
5. Install in reverse order. Make sure that the tie rod ends are installed in accordance with the marks made earlier on the thread. If you measured the length of the ends, make sure that after installation it corresponds to the previously measured length.
6. Check the front wheel toe-in angles and have them adjusted at your dealer service center or workshop if necessary.