Air filter elements
1 - additional capacity;
2 - filter housing;
3 - rubber support;
4 - inlet neck;
5 - clamp;
6 - bracket;
7 - sealing ring;
8 - air filter element;
9 - mounting frames.
Withdrawal
Remove the air mass meter. To do this, turn the knurled wheel on the plug to the left and pull off the plug. Loosen the air hose clamp. Pry the two brackets out with a screwdriver.
Unscrew the bolt and remove the air filter housing from the inlet neck and rubber support slightly up.
Unscrew the bolts of the additional capacity and remove it from the air filter housing.
Installation
Install and secure the additional container,
Insert the air filter housing with the lower rubber support into the recess so that the inlet is secured to the fender. Tighten the mounting bolt.
Insert the air mass meter with O-ring and secure it with brackets.
Slide the air hose going to the intake manifold onto the air mass meter and secure it with a clamp.
Plug in the air mass meter plug and turn the knurled wheel to the right.