Removal and installation the rear ride height sensor
Caution: Follow the ESD protection instructions (ESD - Electrostatic Discharge).
1. Disconnect the connector (1).
2. Unscrew the nut (3) and disconnect the rod.
Tightening torque: 8 Nm.
3. Unscrew the screws (4) and remove the sensor.
Note: When installing, make sure that the lever (2) of the ride height sensor is directed away from the sensor towards the right front wheel.
Tightening torque: 5 Nm.
4. Installation should be carried out in the reverse order of removal, taking into account the above notes.
5. Check and, if necessary, adjust the position of the headlights.
[This article is based on data from the website BMWMAN]