Removal and installation the rear axle beam thrust rod
Attention:
- Observe safety precautions when lifting a vehicle.
- Movement without jet propulsion is prohibited.
1. Remove both rods.
2. Lower the rear section of the exhaust system.
3. Loosen the screws (1) and remove the heat-insulating screen (2).
Tightening torque: 5 Nm.
Caution: Failure to follow these instructions may cause the vehicle to slip off the lift, causing serious injury.
Note: When propping up, ensure that:
- the car no longer rose or fell;
- the car did not lift off the lift's support plates.
Caution: Support the rear axle beam by placing a jack under the shaded area.
4. Unscrew the screw (1), press the tunnel insulation down slightly and unscrew the screw (2).
5. Unscrew the screws (4).
Tightening torque: 21 Nm.
6. Loosen the screws (3) and remove the reaction rod (5).
7. Secure the rear axle beam by screwing in the screws (3).
Note: When installing, check the integrity of the threads. If necessary, repair the threads using wire inserts. Check that the parking brake cables are positioned correctly.
Tightening torque: 77 Nm.
8. Reposition both parking brake cable brackets.
Note: Only when replacing the rear axle beam torque rod.
9. Installation should be carried out in the reverse order of removal, taking into account the above notes.
(The original text is available on the website: bmwman.ru)