Withdrawal
1. Apply the handbrake, jack up the front of the car and place it on stands (cm. "Lifting the vehicle and placing it on stands").
Models "sedan"/"tourist", released before September 2001, and models "coupe"
2. Turn out two screws of fastening of the lower ends of a bumper (pic. 6.2).
3. On the model "coupe" remove the clips and pull the fog light cover forward from the bumper (pic. 6.3).
4. Remove the screws (one on each side) and disconnect the lockers of both wheel arches from the bumper (pic. 6.4).
5. Remove the screws (one on each side) bumper to bumper mounts (pic. 6.5).
6. Slightly push the bumper forward, remember the location of the electrical wiring connectors and disconnect them from the bumper.
7. Pull the bumper forward and remove from the vehicle.
Models "sedan"/"tourist", produced since October 2001
8. Turn out two screws of fastening of the bottom ends of a bumper.
9. In the center from the underside of a bumper take the central pins of three clamps, then take out clamps.
10. Remove the screws (one on each side) fastening the bumper to the buffers.
11. Disconnect lockers from a bumper, having moved a bumper a little forward. Do not pull on the bumper, but only on the lockers.
12. Remember an arrangement of sockets of electroconducting and disconnect them from a bumper.
13. Pull the bumper forward and remove from the vehicle.
14. Inspect bumper mounts and replace worn or damaged ones.
Installation
15. Installation is carried out in 8 sequences, reverse to removal. Tighten all nuts and screws securing the bumper securely.