Pull the shift knob firmly up.
Release the front trim from the retaining tabs and remove it together with the bellows.
Pull out the soundproofing insert.
Unfasten the cover from the body from the gearshift console.
Raise the car.
Release lock 1. Remove washer 2. Pull out selector rod 3.
Place a trunnion key at the bottom of the gear lever and turn it 90" counterclock-wise. After that, press the spherical cup upwards and remove the shift lever.
Installation
Lubricate the shift lever ball cups with Moiykore Longtherm 2.
Insert the ball cups so that the lugs on the ball cups fit into the cutouts on the switch console. Insert the lever and press until the clamps double click.
Insert the shift rod. Put a washer on the finger, insert the stopper of the gearshift rod into the finger.
Lower the car.
Insert bellows. In this case, put the inner boot on the shift lever, and insert the outer boot into the cutout in the body.
Insert damping insert. The rubber mat must be positioned between the floor mat and the center console.
Connect the lining with the corrugated cover at the back, and snap it into place in the front.
Place the shift knob in the notch and push it hard.